Barbell Squat
How to do the Barbell Squat
- 1
This exercise is best performed inside a squat rack for safety purposes. To begin, first set the bar on a rack to just below shoulder level. Once the correct height is chosen and the bar is loaded, step under the bar and place the back of your shoulders (slightly below the neck) across it.
- 2
Hold on to the bar using both arms at each side and lift it off the rack by first pushing with your legs and at the same time straightening your torso.
- 3
Step away from the rack and position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times and also maintain a straight back. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances discussed in the foot stances section).
- 4
Begin to slowly lower the bar by bending the knees and hips as you maintain a straight posture with the head up. Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees. Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
- 5
Begin to raise the bar as you exhale by pushing the floor with the heel of your foot as you straighten the legs again and go back to the starting position.
- 6
Repeat for the recommended amount of repetitions.
How to program the Barbell Squat
Sets and reps
As a compound movement, the Barbell Squat responds well to heavier loading. For strength, work in the 3–5 sets of 4–8 reps range with 2–3 minutes of rest between sets. For muscle growth, 3–4 sets of 8–12 reps with 90 seconds of rest is the classic hypertrophy zone. Place it early in your session, when you're freshest, and leave 1–3 reps in reserve on most sets.
Progression
The Barbell Squat is beginner-friendly. Start with a load (or rep count) you can complete with clean form on every set, then add a small amount of weight or 1–2 reps each week. When you hit the top of your rep range on all sets, increase the load and drop back to the bottom of the range — simple double progression.
Secondary muscles worked
Put the Barbell Squat into a plan
Generate a free, personalized workout plan that programs this and hundreds of other exercises around your goals.
Frequently asked questions
What muscles does the Barbell Squat work?
The Barbell Squat primarily targets the Quadriceps. It also recruits the Calves, Glutes, Hamstrings, Lower Back as supporting muscles.
What equipment do I need for the Barbell Squat?
You need Barbell. Difficulty level: Beginner.
How many sets and reps of the Barbell Squat should I do?
For strength, do 3–5 sets of 4–8 reps with 2–3 minutes rest. For muscle growth, do 3–4 sets of 8–12 reps with about 90 seconds rest.
