Dumbbell Squat To A Bench
How to do the Dumbbell Squat To A Bench
- 1
Stand up straight with a flat bench behind you while holding a dumbbell on each hand (palms facing the side of your legs).
- 2
Position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance and also maintain a straight back. This will be your starting position. Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances discussed in the foot stances section.
- 3
Begin to slowly lower your torso by bending the knees as you maintain a straight posture with the head up. Continue down until you slightly touch the bench behind you. Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
- 4
Begin to raise the bar as you exhale by pushing the floor with the heel of your foot mainly as you straighten the legs again and go back to the starting position.
- 5
Repeat for the recommended amount of repetitions.
How to program the Dumbbell Squat To A Bench
Sets and reps
As a compound movement, the Dumbbell Squat To A Bench responds well to heavier loading. For strength, work in the 3–5 sets of 4–8 reps range with 2–3 minutes of rest between sets. For muscle growth, 3–4 sets of 8–12 reps with 90 seconds of rest is the classic hypertrophy zone. Place it early in your session, when you're freshest, and leave 1–3 reps in reserve on most sets.
Progression
The Dumbbell Squat To A Bench is rated intermediate. Earn the right to progress: only add load when every rep of every set moves with consistent technique. Video your sets or use a mirror to check positions, and use double progression (add reps to the top of your range, then add load and reset) rather than jumping weight.
Secondary muscles worked
Put the Dumbbell Squat To A Bench into a plan
Generate a free, personalized workout plan that programs this and hundreds of other exercises around your goals.
Frequently asked questions
What muscles does the Dumbbell Squat To A Bench work?
The Dumbbell Squat To A Bench primarily targets the Quadriceps. It also recruits the Calves, Glutes, Hamstrings, Lower Back as supporting muscles.
What equipment do I need for the Dumbbell Squat To A Bench?
You need Dumbbell. Difficulty level: Intermediate.
How many sets and reps of the Dumbbell Squat To A Bench should I do?
For strength, do 3–5 sets of 4–8 reps with 2–3 minutes rest. For muscle growth, do 3–4 sets of 8–12 reps with about 90 seconds rest.
