Front Barbell Squat To A Bench
How to do the Front Barbell Squat To A Bench
- 1
This exercise is best performed inside a squat rack for safety purposes. To begin, first set a flat bench behind you and set the bar on a rack that best matches your height. Once the correct height is chosen and the bar is loaded, bring your arms up under the bar while keeping the elbows high and the upper arm slightly above parallel to the floor. Rest the bar on top of the deltoids and cross your arms while grasping the bar for total control.
- 2
Lift the bar off the rack by first pushing with your legs and at the same time straightening your torso.
- 3
Step away from the rack and position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance and also maintain a straight back. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances described in the foot positioning section).
- 4
Begin to slowly lower the bar by bending the knees as you maintain a straight posture with the head up. Continue down until you touch the bench with your glutes. Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
- 5
Begin to raise the bar as you exhale by pushing the floor mainly with the heel of your foot as you straighten the legs again and go back to the starting position.
- 6
Repeat for the recommended amount of repetitions.
How to program the Front Barbell Squat To A Bench
Sets and reps
As a compound movement, the Front Barbell Squat To A Bench responds well to heavier loading. For strength, work in the 3–5 sets of 4–8 reps range with 2–3 minutes of rest between sets. For muscle growth, 3–4 sets of 8–12 reps with 90 seconds of rest is the classic hypertrophy zone. Place it early in your session, when you're freshest, and leave 1–3 reps in reserve on most sets.
Progression
The Front Barbell Squat To A Bench is rated expert. Earn the right to progress: only add load when every rep of every set moves with consistent technique. Video your sets or use a mirror to check positions, and use double progression (add reps to the top of your range, then add load and reset) rather than jumping weight.
Secondary muscles worked
Put the Front Barbell Squat To A Bench into a plan
Generate a free, personalized workout plan that programs this and hundreds of other exercises around your goals.
Frequently asked questions
What muscles does the Front Barbell Squat To A Bench work?
The Front Barbell Squat To A Bench primarily targets the Quadriceps. It also recruits the Calves, Glutes, Hamstrings as supporting muscles.
What equipment do I need for the Front Barbell Squat To A Bench?
You need Barbell. Difficulty level: Expert.
How many sets and reps of the Front Barbell Squat To A Bench should I do?
For strength, do 3–5 sets of 4–8 reps with 2–3 minutes rest. For muscle growth, do 3–4 sets of 8–12 reps with about 90 seconds rest.
